1. Check all parts of the screws before work and be sure to tighten them. The process is to manually pass the cold drawn wire through the drum and cutter from the feed port, then adjust the angle according to the diameter of the cold drawn wire , and then supply power.
2. It is not allowed to stack items on the cold-drawn wire straightening machine to prevent mechanical vibration from falling into the body.
3. The rack and chute should be installed straight and aligned with the middle line of the guide cylinder, straightening cylinder and the lower knife hole.
4. Rotate the flywheel by hand, check the transmission mechanism and working device, adjust the gap, tighten the bolts, and after confirming that it is normal, start idling, check that the bearings should have no abnormal noise and the gears mesh well. Operation can only be performed after normal operation.
5. According to the diameter of the straightening steel bar, select the appropriate straightening block and transmission speed. Feeding must be commissioned before proceeding.
6. Before the calibration block is fixed and the protective cover is put on, no feeding is allowed. It is forbidden to open the protective cover and adjust the gap during operation.
